Diagnostic Codes - PIAGGIO Beverly 500 i.e. Workshop Manual

Injection
- Remove the original master key transponder and install it on the master key of the new cylinder.
- Program the system again as described above.
2 Decoder replacement
When the decoder is replaced it is necessary to program the system again.
Programming is indispensable for the engine start-up. (see System programming).
3 Control unit replacement
Programming is indispensable when the control unit is replaced to enable the engine start-up.
In this case it is sufficient to switch to "ON" using the master key.
N.B.
- THE SERVICE KEY (BLACK-COLOURED) IS NOT USED FOR PROGRAMMING.
- WHEN NOT PROGRAMMED, THE CONTROL UNIT ALLOWS NO FUNCTIONAL DIAGNOSIS ON
THE ENGINE.
4 Replacing or duplicating service keys
Keys can be duplicated using the blank keys and the original master key.
A copy may also be requested using the scooter CODE CARD.
Program the system again using the master key and all service keys (see System programming).
N.B.
THE CODE CARD CAN ONLY BE USED WHEN THE ORIGINAL MASTER KEY IS AVAILABLE.

Diagnostic codes

The LED indication is divided into 3 steps:
1st step: A flash: "ON" switching recognition
2nd step: Series of flashes: diagnosis code indication
3rd step: Steady light on or off:
on = start-up disabled off = start-up enabled
Code 1
Code 1 indicates a non-programmed system.
If the code is still displayed after having carried out
the programming procedure, repeat the procedure
carefully observing the "ON" times of each key.
If the code is still displayed, proceed as follows:
- Disconnect the battery negative.
- Remove the control unit connector.
- Connect the special tool between the injection system and the control unit.
- Remove the main decoder connector.
INJEC - 220
Beverly 500 i.e.