Refitting The Injector - PIAGGIO Beverly 500 i.e. Workshop Manual

Hide thumbs Also See for Beverly 500 i.e.:

Table of Contents

- To remove the injector, remove the central set

screw of the "T" shunt acting as a support for the

- Remove the injector from the manifold.

- Once the engine is repaired check the CO% value again while idling to make sure it is within the

prescribed limits. If the CO% is not in conformity, proceed with calibration as described in the "Carbu-

retion adjustment" chapter.

Refitting the injector

Carefully check to make sure the components are

- Fit new O-rings and grease them.

- Apply the recommended product to the set

screws and tighten to the prescribed torque.

Table of Contents