Required Installation Tools; Installation Instructions; Figure 4 Single Monitor Connection - Honeywell HHMC21 Installation Manual

2.1

REQUIRED INSTALLATION TOOLS

Installing the HMC21 monitor does not require any special tools.
2.2

INSTALLATION INSTRUCTIONS

WARNING :
The monitor should be installed in an area that is clean, dry and well ventilated.
Do NOT install the monitor where it can get wet; such as near pools, sinks, open
windows, etc. Do NOT install the monitor in excessively dusty areas; dust can
block ventilation holes causing the monitor to overheat. Operate the monitor on
flat firm surfaces; NOT on surfaces such as rugs, carpet, beds or sofas because
these can block ventilation holes on the bottom of the monitor. Do NOT install
the monitor where items such as drapes or curtains can block ventilation holes. If
the monitor is installed in a rack, make certain it has sufficient ventilation.
WARNING:
If the monitor's plug does not fit your power outlet, do NOT modify the plug.
Have a certified electrician update your power outlet. Do NOT route the power
cord where individuals can trip on it. Do NOT route the power cord where it can
be damaged such as under a rug.
Place the monitor on a flat sturdy surface near a power outlet. Connect the video
input cable to the
VCR, multiplexer or the loop output of another monitor.
A second video source can be connected to the
If your video source has an audio output, connect the audio from source "A" to
Audio A In
Video A In
and audio from source "B" to
Figure 4 - Single monitor connection
connector. The video input can be from a camera,
AUDIO B In.
HMC21
Monitor
10
Video B In.
Video Camera
VCR