Maintenance; Specifications - JVC CA-UXG45 Instructions Manual

Micro component system consists of ca-uxg45 and sp-uxg45
Hide thumbs Also See for CA-UXG45:
Table of Contents

Advertisement

Maintenance

To get the best performance of the System, keep your discs,
and mechanism clean.
Handling discs
• When removing the disc from its case, hold it at the edge while
pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc.
• Avoid exposure to direct sunlight, temperature extremes, and
moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center to
edge.
Handling cassette tapes
• If the tape is loose in its cassette, take up the slack by inserting
a pencil in one of the reels and rotate it.
– If the tape is loose, it may get stretched, cut, or caught in the
cassette.
• Be careful not to touch the tape surface.
• Avoid the following places to store the tape—in dusty places,
in direct sunlight or heat, in moist areas, on a TV or speaker,
or near a magnet.
To keep the best recording and playback sound quality
• Use a cotton swab moistened with alcohol to clean the heads,
capstans, and pinch rollers.
• Use a head demagnetizer (available at electronics and audio
shops) to demagnetize the heads (when the System turned off).
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System is
heavily stained, wipe it with a cloth soaked in water-diluted
neutral detergent and wrung well, then wipe clean with a dry
cloth.
• Since the System may deteriorate in quality, it become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it strongly.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as insecticides
to it.
– DO NOT allow any rubber or plastic to remain in contact for
a long time.

Specifications

Amplifier section
Output Power:
80 W per channel, min. RMS,
driven into 6 Ω at 1 kHz with no
more than 10% total harmonic
distortion. (IEC268-3)
6 Ω – 16 Ω
Speakers/Impedance:
Audio Input
AUX
USB: Ver.1.1
Tuner section
FM tuning range:
87.50 MHz – 108.00 MHz
AM (MW) tuning range: 531 kHz – 1 710 kHz (at 9 kHz)
530 kHz – 1 710 kHz (at 10 kHz)
CD player section
Dynamic range:
85 dB
Signal-to-noise ratio:
85 dB
Wow and flutter:
Immeasurable
Cassette deck section
Frequency response
Normal (type I):
60 Hz – 14 000 Hz
Wow and flutter:
0.15% (WRMS)
General
Power requirement:
AC 110 V – 127 V / 220 V – 240 V
(adjustable with the voltage selector),
50Hz/60Hz
Power consumption:
150 W (at operation)
22 W (on standby)
1.0 W (standby and on display off)
175 mm × 246 mm × 415 mm
Dimensions (approx.):
(W/H/D)
Mass (approx.):
6.2 kg
Speakers
Type:
2-way Bass reflex
Woofer: 12 cm cone × 1
Speaker units:
Tweeter: 4 cm cone × 1
6 Ω
Impedance:
145 mm × 246 mm × 212 mm
Dimensions (approx.):
(W/H/D)
Mass (approx.):
2.2 kg each
Supplied Accessories
See page 4.
Design and specifications are subject to change without notice.
Input sensitivity/Impedance:
LEVEL1: 150 mV/47 kΩ
LEVEL2: 500 mV/47 kΩ
28

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lvt1520-005bSp-uxg45Ux-g45

Table of Contents