Compact Disc Maintenance - JVC RD-E861B-DAB Instruction Manual

Dab+ all-in-one audio system
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

COMPACT DISC MAINTENANCE

Always use a compact disc bearing the mark as shown.
Notes on handling discs
• Removing the disc from its storage case and loading it.
• Do not touch the reflective recorded surface.
• Do not stick paper or write anything on the surface.
• Do not bend the disc.
Storage
• Store the disc in its case.
• DO not expose discs to direct sunlight or high temperatures, high humidity or dusty places.
Cleaning a disc
• Should the disc become soiled, wipe off dust, dirt and fingerprints with a soft cloth.
• The disc should be cleaned from the center to the edge.
• Never use benzene, thinners, record cleaner fluid or anti-static spray.
• Be sure to close the CD door, so the lens is not contaminated by dust.
• Do not touch the lens.
USB
NOTE: The device supports USB drives (FAT32) with up to 32 GB of memory. Only support MP3
audio format. Do not use any USB extension cable for connecting the USB drive. The unit may not be
compatible with all USB drives, this is not an indication of a problem with the unit.
• In USB mode, insert a USB drive into the USB port. The display shows the total number of
folders/tracks.
• The playback starts automatically. If not press
• To view the ID3 info, press INFO on the remote control.
Playback / Playback modes / Programmed playback
All playback features are the same as MP3-CD, see section above.
AUX
This unit provides AUDIO IN socket, through this 3,5 mm jack external audio sources can be
connected to this unit and be amplified.
• In AUX mode, connect your device with a cable (not included) to the AUDIO IN socket.
• Adjust the volume to your desired level.
NOTE: When using an external device, all playback features can only be controlled by the external device.
4-hour playback
If the unit is in AUX mode for more than 4 hours, it will automatically switch to standby mode.
10 minutes before entering standby, <AUTO-OFF> will flash on the display. To cancel the auto-
off function press INTRO.
.
EN

Advertisement

Table of Contents
loading

Table of Contents