Listening To The Radio - JVC CA-UXG45 Instructions Manual

Listening to the Radio

To select the AM tuner interval spacing
Some countries space AM stations 9 kHz spacing, and other
countries use 10 kHz spacing.
You can change the AM tuner intervals while the System is
on stand by.
1
2
sec.
• Current interval setting appears on the display.
2
Select the interval spacing while current setting
appears on the display.
9
0
To select the band (FM or AM)
You can also carry out the same operation using the FM/AM
button on the System.
To tune in to a station
While FM or AM is selected...
Remote control:
1
sec.
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually, press either button.
Remote
ONLY
FM AM
Main unit:
1
sec.
DOWN UP
If the received FM station is hard to listen
FM MODE
MONO: Reception will improve though stereo
effect is lost. MONO indicator lights up.
STEREO: Normally select this. Stereo effect will
be resumed.
To preset the stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
2
Activate the preset number entry mode.
SET/RESUME
• Finish the following process while the indication on the
display is flashing.
3
Select a preset number for the station you store.
Examples:
1 3
2
To select preset number 5, press
5.
4 5 6
To select preset number 15, press
7 8 9
To select preset number 30, press
0
10
• You can also use the PRESET UP/PRESET DOWN
buttons.
4
Store the station.
SET/RESUME
memo
• If you preset a station set to MONO, the station is stored
with the MONO setting.
Remote
ONLY
MONO
STEREO
Remote
ONLY
10 → 1 → 5.
10 → 3 → 0.
10