Coin-Cell Battery - Dell XPS M1710 Owner's Manual

NOTICE: To avoid damaging the system board, you must remove the battery before you begin working inside the computer.
1. Follow the procedures in Before You
2. Open the display and remove the hinge cover. See
3. Remove the keyboard:
a. Remove the two screws at the top of the keyboard.
NOTICE: The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
b. Lift the keyboard and hold it up and slightly forward to access to the keyboard connector.
c. To disconnect the keyboard cable from the keyboard connector on the system board, rotate the keyboard connector latch toward the front of the
computer.
d. Slide the keyboard cable out of the keyboard connector on the system board.
1 keyboard
4 keyboard connector latch
NOTICE: To avoid scratching the palm rest when replacing the keyboard, hook the five tabs along the front edge of the keyboard into the palm rest,
and then secure the keyboard in place.
Coin-Cell Battery
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To avoid damaging the system board, you must remove the battery before you begin working inside the computer.
1. Follow the procedures in Before You
2. Remove the hinge cover. See
3. Remove the keyboard. See Keyboard.
4. Remove the existing coin-cell battery:
a. Pull up on the connector to disconnect the battery cable from the system board.
b. Press the release latch on the side of the coin-cell battery compartment, and lift the battery.
Begin.
Hinge Cover.
2 keyboard screws (2)
5 keyboard tabs
Begin.
Hinge Cover.
3 keyboard cable