Sailing Yacht Bavaria 42 Cruiser
1.3 Drive systems
1.3.1 Sails
The SY Bavaria 42 is equipped with the following standard sails:
Main sail standard
Main sail (fully-battened)
Genoa 150%
Fock
Spin
1.3.2 Rigging
Mast
LM- Profile, without taper; – 18 deg. double spreaders , angular; - 2 halyards, topping- and
-
boom lifts,
tipping line and fittings.
-
Boom
LM-Profile; - clew outhaul; - 2 reefing lines; - eye for mainsheet; - eye for tipping line.
-
Standing rigging (made of 1x19–lace, material 4401), consisting of:
forestay with excessive footage (headsail reef system)
intermediate shroud
lower shroud
upper shroud
Running Rigging
Inside the mast:
- Main halyard
- Genoa halyard
- Boom lift
- 3 additional weighing lines
Additionally we draw your attention to the enclosed trim instructions of the manufacturer.
Attention
- Before you start a sailing turn:
- Check all wires, ropes and lines, rigging screws and splints.
- The latter should be secured with tape or by bending them. Exchange damaged
or deformed bolts.
1.3.3 Motorising, engine room, gear, and propeller
This yacht is equipped with a inboard diesel engine with a sail-drive gear and a fixed propeller
(option: folded propeller).
The engine room is separated from living quarters by plywood-bulkheads covered with sound-
insulating material. An access is possible through:
a shutter below the companion way,
-
detachable bulkhead in the aft cabin beside the engine room
-
Cooling-water supply to the engine is realised via the sail drive-gear (extra drain with shaft).
abt 43 sqm
abt 43 sqm
abt 53 sqm
abt 36 sqm
abt 125 sqm
2x
permanent backstay
2x
permanent backstay tackle
2x
Option:
- Spinnaker halyard (attached)
- Spinnaker uphaul
- Spinnaker downhaul
16 of 43
Bavaria Yachtbau GmbH
1x
1x
1x