MTU 12 V 4000 C10 Operating Instructions Manual page 93

Removing injector
Note: Always replace the first and last injectors of
one engine side first. Replace the inner in‐
jectors only after the installation of the outer
injectors on this engine side is completed.
1. Release the cable terminal threaded con‐
nection (arrows) on the injector and remove
cable terminals.
2. Remove screw (2) and take off hold-down
clamp (1).
3. Remove high-pressure fuel line (5).
4. Install installation/removal device on the
cylinder head.
5. Remove injector with installation/removal
device.
6. Remove the installation/removal device.
MS150049/02E 2012-11 | Task Description | 93