Change Site Information; Change Self Monitoring; Change Passcodes - 3M G5 Installation Manual

Change Site Information

Change Self Monitoring

Change Passcodes

3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
Site information is useful for warranty registration and to support service calls.
This information is most useful when the system has an internet connection.
Tech Services can use it to identify and contact the store when it receives a
service request. All information is entered free-format using the numeric
keypad. To type upper case letters, use the Shift key.
Perform the following procedure to change the site information:
•
Enter the base station configuration mode, see page 35.
•
Navigate to
•
For each field that needs to be modified, enter the appropriate data.
(Press , , , and  to scroll through the fields.)
Self-monitoring is a function available for all systems where the base station is
continuously connected to a store Ethernet connection. The base station keeps
track of all of the headsets in the system, looking for periods of extended non-
use that may indicate a headset problem that needs attention.
Perform the following procedure to enable and configure self monitoring:
•
Enter the configuration mode, see page 35.
•
Select
12 Self Monitoring
•
To enable or disable self monitoring, change the value for
Monitoring Enabled?
•
If self monitoring is enabled:
•
Select a value for
The range is 7 to 255. The number represents how many days of
inactivity must pass for any given headset before the system
interprets the absence as a problem and forwards the information
to 3M.
•
Select a value for
Never
the frequency that the base station will attempt to resend the
error message until the error condition is corrected.
User and installer passcodes can be individualized for better security control
against unauthorized changes. The system has a default user and a default
installer passcode pre-installed. Check your documentation for those passcodes.
User Passcodes
If you enter a user passcode, you have full access to the Change User Passcodes
menu. You can change or delete any passcode.
Perform the following procedure to set up and/or change user passcodes:
•
Enter the configuration mode, see page 35.
•
Select
13 Change Passcodes
•
Identify the user number you want to change, then press , , , and
 as necessary to scroll to the desired passcode.
•
Enter a new four-digit passcode in place of the old passcode.
•
Press
Enter
change and leave the passcode at its previous setting.
.
11 Site Information
.
to or
Yes No
Number of Inactive Days Allowed
Resend Error Reports
, ,
Every Day Every Week
>
Change User Passcodes
to implement the change or press
Configuration
Self
.
. Your choices are
, or . This is
Every Month
.
to abandon the
Mode
March 2014 – Revision 2.0
Page 51 of 74
.