Install The Base Station - 3M G5 Installation Manual

Install the Base Station

3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
Choose a Location
Generally, the base station should be located centrally, and close to the order
takers. However there are several important guidelines that must be followed to
reduce the risk of problems. Follow the guidelines to ensure that the base
station(s) can communicate with headsets in any foreseeable location:
•
Do not assume that the location of an old base station is suitable for a
new base station.
•
The LCD screen should be approximately 5 ft (1.5 m) from the floor.
•
The base station should be at least 3 ft (1 m) from large metallic
fixtures or appliances.
•
The base station should be within 6 ft (2 m) of a 110VAC, 15A or 20A
electrical outlet.
•
The base station should be placed away from inside corners, airborne
grease, and moisture.
•
Easily visible and the keypad accessible.
Pre-Testing the Location
Before you permanently mount the base station(s), one person can pre-test the
signal using the following procedure:
•
Temporarily mount the base station where you think it may have good
range.
•
Power the base station.
•
Register two headsets.
•
Change the order taking mode to Always On.
•
Put on two headsets.
•
Tap the talk button on one of the headsets.
•
Walk around the location, talking as you walk.
 If you can hear yourself in the other headset in all desirable order-
taker positions, the base station is in a suitable location.
 If you cannot hear yourself in the other headset in all desirable
order-taker positions, the base station should be move to a
different location.
Important Notes:
To ensure the best operating range for your system, locate the base station
where it is not within three feet of or blocked by large steel structures such as
doors, walls, or large appliances.
If you plan to use an outside order taker, be sure that the base station's range
includes the outside order taker location.
If the best location you find is still unable to communicate to all areas, you
may need to install an external antenna.
Removing and Replacing the Cover
To remove the base station cover:
•
Disconnect power from the base station.
•
Loosen the two screws located at the bottom of the cover.
Installation
March 2014 – Revision 2.0
Page 19 of 74