Access Via Cli - THOMSON 780 (WL) User Manual

Chapter 1
Getting to know your SpeedTouch™

1.2.2 Access via CLI

To access the
SpeedTouch™ via the
Command Line
Interface (CLI)
8
You can access the Command Line Interface (CLI) via:
A Telnet session
This requires a TCP/IP connection between the host from which the Telnet
session is opened and the SpeedTouch™. Your SpeedTouch™ and the
connected computer must have an IP address in the same subnet.
Quote site commands (over FTP)
For more information, see
For more information on CLI commands, see the SpeedTouch™ CLI Reference
Guide.
" Quote site command" on page 12.
E-DOC-CTC-20051017-0149 v1.0