THOMSON 780 (WL) User Manual page 20

Chapter 1
Getting to know your SpeedTouch™
FTP file transfer
Quote site command
12
To allow correct file transfers, set the transfer mode to "binary": at the ftp prompt,
bin
type and press ENTER.
Turn on the hashing option to see the progression of the file transfer: At the
hash
ftp prompt, type
Example.
/home/doejohn{1}$ftp 192.168.1.254
Connected to 192.168.1.254
220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to change.
Name (192.168.1.254:doejohn):
331 SpeedTouch™ (00-90-D0-01-02-03) User 'doejohn' OK. Password requir
ed.
Password : ######
330 OK
ftp>
ftp>bin
200 TYPE is now 8-bit binary
ftp>
ftp>hash
200Hash mark printing on (8192 bytes/hash mark).
ftp>cd dl
250 Changed to /dl
ftp>put C:\user.ini
200 Connected to 192.168.1.10 port 1271
150 Opening data connection for user.ini
226 File written successfully
ftp: 256 bytes sent in 0,000Seconds 256000,000Kbytes/sec.
ftp>
All the CLI commands can be executed from within an FTP session. Only complete
CLI commands (in other words, the complete command syntax with all the
parameters already specified) can be executed.
Example: To execute the CLI command
currently assigned to SpeedTouch™ interfaces, at the FTP prompt, type 'quote site
ip iplist' and press ENTER.
quote site ip iplist
ftp>
200- Interface
200- 2 LocalNetwork
200- 2 LocalNetwork
200- 1 Internet
200- 0 loop
200-
200 CLI command "ip iplist" executed
ftp>
For more information on CLI commands, see the SpeedTouch™ CLI Reference
Guide.
and press ENTER.
:ip iplist
Type IP-address
Ethernet 10.0.0.138
Ethernet *192.168.1.254
Serial 81.240.198.191
Internal 127.0.0.1
to list all IP addresses
Point-to-point/Mask
255.255.255.0
255.255.255.0
81.240.198.1
255.255.255.255
E-DOC-CTC-20051017-0149 v1.0