Panasonic KX-TD816CE Installation Manual page 16

Installing the Expansion Unit (KX-TD290)*
7. Insert the plug into a jack on the unit.
Connect an earth wire to the earth terminal
on the extension expansion unit.
8. Tie all of the cords into a bundle. If other
cords are exposed from the upper cabinets,
tie them also.
9. Close the cabinet cover and secure the
outside screw.
10. Cover the cords with the cord holder
(included with the main unit).
16
8
7
6
RB
RA
5
4
3
2
TB
TA
1
View of TEL Jack
To Terminal Board or Modular
Jacks from the Central Office
Cord holder
11. Fix the cords to the wall as
shown here, so that the front
cover can be opened.
Note • If two or three expansion units are
installed, cut the cabinet covers on the
lower cabinets to allow the cords from
the upper cabinets to go down through
the cabinet covers. To protect the
cords, smooth the cut edges.
Programming Reference
In this manual
Section 4, System Programming
[109] Expansion Unit Type
*: Available for the KX-TD1232 Master system only.
Cut here