Table of Contents
Advertisement
3. installation
• Installation must be carried out by skilled authorised LA SAN MARCO SPA technical
personnel.
• The coffee machine is delivered in suitable packaging. The packaging contains the
machine and its accessories, the user manual and the conformity declaration. After
opening the packaging, make sure the coffee machine and its components are intact.
In case of doubt, do not use the appliance, and contact the manufacturer.
• All of the packaging must be carefully set aside in case the machine needs to be trans-
ported in future.
• The machine should be placed on a perfectly horizontal surface, which is sufficiently
sturdy to support the weight of the machine, with a sufficient clearance around it to
dissipate the heat generated during its operation.
• Do not install the espresso coffee machine in places where cleaning is to be carried out
with jets of water. Do not immerge the unit in water to clean it.
• For safety against hazards related to electrical currents, keep the machine away from
sinks, tubs, aquariums, taps, and areas that are wet or where water may splash.
• The machine creates heat. Therefore it needs to be placed in a room that is sufficiently
ventilated to ensure heat dissipation. Keep the machine away from sources of direct
heat.
• Make sure that the voltage of the power socket does not differ from that indicated in
the technical data and on the identification plate affixed to the machine. If the voltage
is different, do not connect the machine. This may be dangerous and may damage the
appliance.
3.1 Equipment provided
The machine packing contains the equipment kit, which includes the following items:
– filter cups with filter restraint ring
– filters for filter cups (single and double doses)
– blind filter for filter cup
– filters for filter cups (single and double doses)
– press for ground coffee
– rubber tube with stainless steel mesh for water connection (water circuit - water softener)
– rubber drain hose with steel coil for water drain
– 3/8" nipples for hose connection to water supply tube
– cleaning brush for serving units
3.2 Water mains set-up
FEEDING lINE
bring the water feeding tube (at least 3/8" in diameter) up to the machine and install an cut-off valve (prefer-
ably of 3/8" ball type) that allows a rapid opening and closing operation. The appliance should be connected
to the water mains using the tube supplied with it. Do not connect the appliance with used tubes.
DRAIN lINE
Provide an inspectable drain pit on the floor connected with the sink drain line, suitable for receiving the ma-
chine gravity drain tube. The drain tube must be positioned so that the water flows out freely, without it being
possible for the pipe to clog up during operation.
3.3 Water softener (optional)
The water softener for softening the mains water can be manual or automatic, depending on
customer's request.
Before connecting the water softener to the coffee machine, the resins contained in it should be
washed off as described in the user manual supplied with the appliance.
8
Hide quick links:
Advertisement
Table of Contents
