Plastics Flammability; Texture/Glossing Of Housing; Tilt And Swivel Base; Kensington Lock - Philips 190S8FS/00 Service Manual

5.8 If paint is used
RoHS required
WEEE require
If new painting type need to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.

5.10 Plastics flammability

All Plastics to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg; UL94-V0 is OK).
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover, base) need to be molded from same resin.
ABS V0 is allowed to implement in China region for monitor body major plastic parts
(bezel, back cover, base).
Plastic resin type selection should be referred to "TY R83-2-9002-1"s.

5.11 Texture/Glossing of housing

The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
< = 20 gloss units

5.12 Tilt and swivel base

Tilt angle
Swivel angle : ±45° ( not request for 190S8 )
High Adjustment : 130mm ( not request for 190S8 )
Portrait Display : -1° +1/-0°~+91° +0/-1° CCW ( not request for 190S8 )

5.13 Kensington Lock

Must meet Kensington_slot.spec "TYE-M0004".
MMD request metal plate in Kinsington hole.

5.14 Label

Regulatory label / Carton label should follow Philips requirement.
China RoHS label
Detail document refer to Philips Engineering Reference Book.
-5 ° +2/- 0 ° (forward)
:
+20 °+3/-0 ° (backward)
103
HUDSON 8
103