Scanning Frequencies; Electrical Characteristics; Interface Signals; Video: 0.7 Vp-P, Input Impedance, 75 Ohm @Dc - Philips 190S8FS/00 Service Manual

White luminance
Color gamut
Gate IC
Source IC
Response time

2.2 Scanning frequencies

Hor. : 30 – 83 K Hz
Ver.: 56 - 76 Hz
Video dot rate: 165 MHz
Power input: 90-264 V AC, 50/60 ± 2 Hz
Power consumption : : 36 W typical
Functions:
(1)D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature:

3. Electrical characteristics

3.1 Interface signals

1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)

3.2 Interface

3.2.1 D-Sub Cable
Length
Connector type
Blue connector thumb-operated jack screws
: 300 nits (typ)
: 72% (typ)
:
:
: 5ms
0 °C - 35 °C
TTL level , input impedance 2.2k ohm terminate
: 1.8 M +/- 50 mm
: D-Sub male with DDC2B pin assignments.
91
HUDSON 8
(Positive/Negative)
91