How To Stop The Engine - Perkins 4006-23TAG1A User Handbook Manual

3
4 If the engine does not start after 10 seconds allow the start key to return to the 2 position for 20 seconds,
then engage the starter motor again.
Note: After the engine has started check the oil pressure gauge.
5 If the engine fails to start after the third time, see "Problems and possible causes" on page 40.

How to stop the engine

Cautions:
! Allow the engine to run for 3 to 5 minutes with no load, to remove the heat away from the turbochargers,
bearings, and seals before the engine is stopped. Failure to do this may damage your engine.
! If the engine is stopped due to the operation of the air shut off valves, the cause must be checked
immediately.
Turn the start key to position (A1). This will automatically stop the engine.
The engine can be stopped manually by the stop control lever. Hold the lever in the stop position (B) until the
engine is stopped.
A
18
1
2
3
D1105/1
B
User's Handbook, TPD 1508E, issue 1
4000 Series
D1044