Connecting The Speakers - JVC RX-7030VBK Instructions Manual

Audio/video control receiver
Hide thumbs Also See for RX-7030VBK:
Table of Contents

Advertisement

AM Antenna Connections
ANTENNA
AM
EXT
AM Loop Antenna
AM
LOOP
(supplied)
Snap the tabs on the loop into the slots
of the base to assemble the AM loop.
FM 75
COAXIAL
2
1
Outdoor single vinyl-covered wire (not supplied)
Notes:
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One surround back speaker or one pair of surround back speakers
to enjoy to produce more effective surround effect.
• One center speaker to emphasize human voices.
• One subwoofer to enhance the bass.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
• When connecting to both of the FRONT SPEAKERS 1 and 2
terminals, use speakers with an impedance of 16 Ω to 32 Ω.
• When connecting to either the FRONT SPEAKERS 1 or 2
terminals, use speakers with an impedance of 8 Ω to 16 Ω.
Turn the loop until you have the
best reception.
3
Basic connecting procedure
1 Twist and remove the insulation at
the end of each speaker signal cable
(not supplied).
2 Open the speaker terminal.
(For FRONT SPEAKERS 2 terminals)
3 Insert the speaker signal cable.
4 Close the speaker terminal.
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
Speaker layout
Ideal speaker layout varies depending on the conditions of your
listening room. The diagram below is a recommended typical
example.
Left front speaker(s)
Center speaker
(L)
(C)
Left surround
speaker (LS)
Surround back speakers (LSB/RSB)
RX-7030VBK/RX-7032VSL
Subwoofer
Right front speaker(s)
(R)
Right surround
speaker (RS)
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents