Connecting The Fm And Am Antennas - JVC RX-772VBK Instructions Manual

Connecting the FM and AM Antennas

FM Antenna Connections
1
2
ANTENNA
FM
75
FM
GND
GND
AM
LOOP
AM
EXT
How to strip the 75-ohm coaxial cable and connect it to the FM terminals
1. Strip back the outside covering of the 75-ohm coaxial cable to expose the braided metallic mesh about 13/16 inches (20 mm).
2. Pull the mesh back and twist it into a single connector, as shown in the illustration above.
3. Strip the insulation about 7/16 inches (10 mm) back from the central wire.
4. Insert the twisted mesh and the central wire to the FM terminals, as shown in the illustration above.
AM Antenna Connections
ANTENNA
75
FM
GND
GND
AM
LOOP
EXT
Note:
Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
Page 5
3
FM Antenna
4
1
13/16 in.
(20 mm)
FM
AM Loop Antenna
AM
1
2
Extend the FM wire antenna horizontally.
Outside FM Antenna Wire
2
3
7/16 in.
(10 mm)
Turn the loop until you have
the best reception.
3
Outdoor Single Vinyl-covered Wire
If reception is poor, connect an outdoor single vinyl-covered
wire to the AM EXT terminal. (Keep the AM loop antenna
connected.)
If reception is poor, connect the outside antenna.
Before attaching a 75-ohm coaxial cable (the kind
with a round wire going to an outside antenna),
disconnect the supplied FM antenna.
Snap the tabs on the loop into the slots of
the base to assemble the AM loop.