Basic Operations; Turning The Power On And Off; Selecting The Source To Play - JVC RX-772VBK Instructions Manual

Basic Operations

AUDIO/TV
/VCR
CATV
/SAT

Turning the Power On and Off

STANDBY
POWER
STANDBY
POWER
Front panel
AUDIO
POWER
Remote Control

Selecting the Source to Play

SOURCE
Front panel
Page 11
The following operations are commonly used when you play any sound source.
IMPORTANT
When using the Remote Control, check to see if its remote control mode selector is set to the
correct position:
To operate an audio system, TV, and VCR, set it to the "AUDIO/TV/VCR" position.
To operate a CATV converter and satellite tuner, set it to the "CATV/SAT" position.
On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the
display.
Current source
name appears
100
To turn off the power, press POWER again.
The STANDBY lamp lights up.
From the remote control:
To turn on the power, press AUDIO POWER.
The STANDBY lamp goes off. The name of the current source appears on the display.
To turn off the power, press AUDIO POWER again.
The STANDBY lamp lights up.
You need to select the source before you start playing any source.
On the front panel:
1. Press SOURCE so that the Control % % % % % / fi fi fi fi fi buttons work for selecting the source.
2. Press Control % % % % % / fi fi fi fi fi until the source name you want appears on the display.
The selected source lamp also lights up.
Selected source
name appears
1k 10k
MUTE AUTO TUNED STEREO
FM
AM
CH–
SURROUND PRO LOGIC
SEA
VISUAL CONFIRMATION
100 1k 10k
Volume level is also
shown here
whenever the power
VOLUME is on.
See also
page 31.
MENU
SLEEP
MHz
kHz
3CH LOGIC HALL
LOUDNESS
VOLUME