Table of Contents
Advertisement
6. Press Control % % % % % / fi fi fi fi fi until "–DELAY +" appears on the display.
7. Press Control @ @ @ @ @ / # # # # # to adjust the delay time of the rear speaker output.
8. Press Control % % % % % / fi fi fi fi fi until "TEST" appears on the display, then press Control @ @ @ @ @ / # # # # # to start
9. If necessary, adjust the speaker output balance as follows:
10. Press Control % % % % % / fi fi fi fi fi until "TEST" appears on the display, then press Control @ @ @ @ @ / # # # # # to stop the
11. Press Control % % % % % / fi fi fi fi fi until "CNT TONE" (Center Tone) appears on the display.
12. Press Control @ @ @ @ @ / # # # # # to select the center tone you want.
Front panel
Each time you press the button, the delay time changes as follows:
DELAY 1
DELAY 4
DELAY 1:
Select this when the distance from you to your rear speakers is greater than that to the front
speakers.
DELAY 2:
Select this when the distance from you to your rear speakers is almost equal to that to the
front speakers.
DELAY 3:
Select this when the distance from you to your rear speakers is a little less than that to the
front speakers.
DELAY 4:
Select this when the distance from you to your rear speakers is much less than that to the
front speakers.
Note:
When you have selected "3CHLOGIC," you cannot adjust the delay time.
checking the speaker output balance.
"TEST" starts flashing on the display, and a test tone comes out of the speakers in the following
order:
Left front speaker
Notes:
• No test tone comes out of the rear speakers when you have selected "3CHLOGIC."
• No test tone comes out of the center speaker when you select "PHANTOM" or "OFF" for the center
mode.
• To adjust the rear speaker output level, press Control % / fi until "– REAR +" appears on the
display, then press Control @ / #.
• To adjust the center speaker output level, press Control % / fi until "–CENTER+" appears on the
display, then press Control @ / #.
Notes:
• You cannot adjust the left and right rear speakers output level separately.
• You cannot adjust the rear speakers output level when you have selected "3CHLOGIC."
• You cannot adjust the center speaker output level when you select "PHANTOM" or "OFF" for the
center mode.
test tone.
The center tone adjustment affects the mid-frequency range, which the human voice is mostly made
up of.
Each time you press the button, the display changes to show the following:
SOFT2
SOFT1
To make the dialogue clearer, select "SHARP1" (little) or "SHARP2" (much).
To make the dialogue softer, select "SOFT1" (little) or "SOFT2" (much).
When "FLAT" is selected, no adjustment is applied.
Note:
The center tone cannot be adjusted when sounds do not come out of the center speaker.
DELAY 2
DELAY 3
Center speaker
Rear speakers
FLAT
SHARP1
Right front speaker
SHARP2
Page 28
Hide quick links:
Advertisement
Table of Contents
