Basic Operations; Turning The Power On And Off (Standby); Selecting The Source To Play - JVC RX-6010VBK Service Manual

Basic Operations

The following operations are commonly used when you play any sound source.

Turning the Power On and Off (Standby)

On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of
the current source (or station frequency)
appears on the display.
Current source name appears
SPK
L R
ANALOG
Current volume level is shown here
To turn off the power (into standby mode),
press POWER again.
The STANDBY lamp lights up. A small
amount of power is consumed in standby
mode. To turn the power off completely,
unplug the AC power cord.
From the remote control:
To turn on the power, press AUDIO in the
POWER section.
The STANDBY lamp goes off. The name of the
current source (or station frequency) appears on
the display.
To turn off the power (into standby mode),
press AUDIO in the POWER section again.
The STANDBY lamp lights up.

Selecting the Source to Play

Press one of the source selecting buttons.
On the front panel:
DVD VCR
CD TAPE/CDR
SOURCE NAME
From the remote control:
DVD TV SOUND VCR
CD TAPE/CDR FM/AM
STANDBY
POWER
VOLUME
STANDBY
POWER
AUDIO
TV SOUND
FM/AM
Selected source name appears
DIGITAL AUTO SPK
ANALOG L C R
PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO
S.WFR LFE
LINEAR PCM
DIGITAL LS S RS
CH-
DVD
Select the DVD player.
TV SOUND
Select the TV sound.
VCR Select the video component connected to the
VCR jacks.
CD *
Select the CD player.
TAPE/CDR * Select the cassette deck (or the CD recorder).
FM/AM * Select an FM or AM broadcast.
• Each time you press the button, the band
alternates between FM and AM.
Notes:
• When connecting a CD recorder (to the TAPE/CDR jacks), change
the source name that appears on the display. See page 11 for
details.
• When you have connected some digital source components using
the digital terminals (see page 7), you need to select the digital
input mode.
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk ( * ), the receiver
automatically turns on.
Signal and speaker indicators on the display
The signal indicators light up in the following cases:
• Only the indicators for the incoming signals light up.
• When analog input is selected, "L" and "R" always light up.
The speaker indicators light up only —:
• When the corresponding speaker is activated.
AND
• When the corresponding speaker is required for the DSP mode
selected currently.
Signal indicators light up in
red:
L C R
S.WFR LFE
LS S RS
L: • When digital input is selected: Lights up when the left
channel signal comes in.
• When analog input is selected: Always lights up.
R: • When digital input is selected: Lights up when the right
channel signal comes in.
• When analog input is selected: Always lights up.
C: Lights up when the center channel signal comes in.
LS: Lights up when the left rear channel signal comes in.
RS: Lights up when the right rear channel signal comes in.
S:
Lights up when the monaural rear channel signal comes in.
LFE: Lights up when the LFE channel signal comes in.
Note:
When "SUBWOOFER" is set to "YES" (see page 11),
INPUT ATT SLEEP
VOLUME
Speaker indicators light up
in white:
L C R
S.WFR LFE
LS S RS
lights up.
S.WFR
8