Selecting Different Sources For Picture And Sound; Adjusting The Volume; Listening With Headphones Only - JVC RX-5030VBK Instructions Manual

Basic Operations
Front panel
RX–5032V
PHONES jack SPEAKERS
ON/OFF
Selecting Different Sources for Picture
and Sound
You can watch the picture from a video component while
listening to sound from another component.
Press one of the audio source selection buttons while
watching the picture from a video component such as the
VCR or DVD player.
• Once you have selected a video source, pictures of the
selected source are sent to the TV until you select another
video source.
CD TAPE/CDR FM/AM
SOURCE NAME
On the front panel

Adjusting the Volume

On the front panel
To increase the volume, turn MASTER VOLUME control
clockwise.
To decrease the volume, turn MASTER VOLUME control
counterclockwise.
From the remote control
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
The volume level can be adjusted within a range of
"0" (minimum) to "50" (maximum).
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at a high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
11
MASTER VOLUME
DIMMER control
AUDIO/VIDEO CONTROL RECEIVER
Audio source
selection buttons
TAPE/CDR CD DVD
ANALOG
FM/AM TV SOUND VCR /DIGITAL
From the remote control
Remote control
TA/NEWS/INFO
Audio source
selection buttons
DIMMER

Listening with Headphones Only

You must turn off the speakers when you listen with
headphones.
1
Press SPEAKERS ON/OFF on the front
panel.
"HEADPHONE" appears on the display for a while.
The SPK indicator goes off and the H.PHONE indicator
lights up.
This cancels the Surround/DSP modes currently selected
and activates the HEADPHONE mode (see below).
2
Connect a pair of headphones to the
PHONES jack on the front panel .
HEADPHONE mode
When using the headphones, the following signals are sent
to the headphones regardless of your speaker setting:
–For 2 channel sources, the front left and right channel
signals are sent directly to the headphones.
–For multi-channel sources, the front left/right, center, and
surround left/right channel signals are down-mixed and
then sent to the headphones.
You can enjoy multi-channel sound sources using the
headphones.
Note:
While in the HEADPHONE mode, you cannot use any Surround/DSP
modes (see pages 22 to 25).
SLEEP
DISPLAY MODE
MUTING
VOLUME +/–
Remote
NOT