Turning Off The Sound Temporarily-Muting; Changing The Display Brightness-Dimmer; Turning Off The Power With The Sleep Timer - JVC RX-5030VBK Instructions Manual

Basic Operations
After using the headphones
1
Press SPEAKERS ON/OFF on the front panel to
activate the speakers.
The H.PHONE indicator goes off and the SPK indicator
lights up.
2
Disconnect the headphones.
CAUTION:
Be sure to turn down the volume
• Before connecting or putting on headphones, as high volume can
damage both the headphones and your hearing.
• Before turning on speakers again, as high volume may be output
from the speakers.
Turning Off the Sound
Temporarily—Muting
You can turn off the volume temporarily.
Press MUTING on the remote control to mute the sound
through all speakers or headphones.
• "MUTING" appears on the display and the volume turns off
(the VOLUME indicator goes off).
To restore the sound, press MUTING again.
The VOLUME indicator lights up on the display.
• Turning MASTER VOLUME control on the front panel or
pressing VOLUME +/– on the remote control also restores
the sound.
Basic adjustment auto memory
This receiver memorizes sound settings for each source
when—:
• you turn off the power,
• you change the source, and
• you assign the source name.
When you change the source, the memorized settings for
the newly selected source are automatically recalled.
The following can be stored for each source:
• Input attenuator mode (see page 16)
• Tone adjustment (see page 18)
• Speaker output level (see pages 18 and 19)
• Surround/DSP mode selection (see pages 24 and 25)
Notes:
• You cannot assign and store different settings for digital input
mode and analog input mode.
• If the source is FM or AM, you can assign a different setting for
each band.
Changing the Display Brightness—
DIMMER
You can dim the display.
Press DIMMER.
• Each time you press the button, the display dims and
brightens alternately.
Turning Off the Power
with the Sleep Timer
You can fall asleep while listening to music—Sleep Timer.
Press SLEEP on the remote control repeatedly.
• The SLEEP indicator lights up on the display.
Each time you press the button, the shut-off time changes in
10 minute intervals as follows:
10 20 30
0
(Canceled)
When the shut-off time comes, the receiver turns off
automatically.
To check or change the shut-off time, press SLEEP once.
The remaining time (in minutes) until the shut-off time
appears.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer, press SLEEP repeatedly until
"SLEEP 0MIN" appears on the display. (The SLEEP indicator
goes off.)
• Turning off the power also cancels the Sleep Timer.
For recording
You can record any sources playing through the receiver to a
cassette deck (or a CD recorder) connected to the
TAPE/CDR jacks and the VCR connected to the VCR jacks
at the same time.
While recording, you can listen to the selected sound source
at whatever sound level you like without affecting the sound
levels of the recording.
Note:
The output volume level, tone adjustment (see page 18), and
Surround/DSP modes (see pages 24 and 25) do not affect the
recording.
40 50 60
70
90 80
12