Basic Operations; Turning On The Power; Selecting The Source To Play; Changing The Source Name - JVC RX-5030VBK Instructions Manual

Basic Operations

Front panel
STANDBY/ON
and STANDBY lamp
Source selection
buttons

Turning On the Power

Press STANDBY/ON (or STANDBY/ON
remote control).
The STANDBY lamp goes off. The name of the current source
(or station frequency) appears on the display.
To turn off the power (into standby mode)
Press STANDBY/ON (or STANDBY/ON
remote control) again.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.

Selecting the Source to Play

Press one of the source selection buttons.
The selected source name appears on the display.
On the front panel
DVD
VCR TV SOUND
From the remote control
TAPE/CDR CD
FM/AM TV SOUND
DVD: Select the DVD player.
VCR: Select the VCR.
TV SOUND: Select the TV sound.
CD*: Select the CD player.
TAPE/CDR*: Select the cassette deck (or the CD recorder).
FM/AM*: Select an FM or AM broadcast.
• Each time you press the button, the band
alternates between FM and AM.
RX–5032V AUDIO/VIDEO CONTROL RECEIVER
SOURCE NAME
AUDIO on the
AUDIO on the
CD
TAPE/CDR FM/AM
SOURCE NAME
DVD
ANALOG
/DIGITAL
VCR
Remote control
A/V CONTROL
RECEIVER
1 2
4 5
7/P 8
10 0
TA/NEWS/INFO
DISPLAY MODE
Notes:
• When connecting a CD recorder to the TAPE/CDR jacks, change the
source name to CDR so that "CDR" appears on the display when
selected as the source. See "Changing the Source Name" below.
• When you have connected some digital source components using
the digital terminals (see page 9), you need to select the digital input
terminals (see page 14).
• When you press one of the source selection buttons on the remote
control marked with an asterisk ( * ), the receiver automatically turns
on.

Changing the Source Name

When you have connected a CD recorder to the TAPE/CDR
jacks on the rear panel, change the source name to CDR so
that "CDR" appears on the display when selected as the
source.
CD TAPE/CDR
SOURCE NAME
1
Press TAPE/CDR (SOURCE NAME) on the
front panel.
• Make sure "TAPE" appears on the display.
2
Press again and hold SOURCE NAME
(TAPE/CDR) on the front panel until
"ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE," repeat
the same procedure above (in step 1 , make sure "CDR"
appears on the display).
Note:
Without changing the source name, you can still use the connected
components; however, you may experience one of the following
inconveniences:
• A different source name will appear on the display when you select
the target component.
• You cannot use the digital input (see page 14) for the CD recorder.
• You cannot use the COMPU LINK remote control system (see page
26) to operate the target component.
STANDBY/ON
3
AUDIO
6
9
10
Source selection
buttons
Remote
NOT
FM/AM
10