Tuner Operations; Setting The Am Tuner Interval Spacing; Tuning In To Stations Manually; Using Preset Tuning - JVC RX-5030VBK Instructions Manual

Tuner Operations

Front panel
STANDBY/ON
FM/AM
TUNING 5/∞
Setting the AM Tuner
Interval Spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing. 9 kHz spacing is the initial
setting.
To select the 10 kHz interval:
Be sure the receiver is turned off, but is plugged into an AC
outlet.
Hold down FM/AM TUNING 5 and press STANDBY/ON
"10k STEP" appears on the display. Now the 10 kHz interval is
selected.
FM/AM TUNING
To change back to the 9 kHz interval:
Be sure the receiver is turned off, but is plugged into an AC
outlet.
Hold down FM/AM TUNING ∞ and press STANDBY/ON
"9k STEP" appears on the display. Now the 9 kHz interval is
selected.
FM/AM TUNING

Tuning in to Stations Manually

1
Press FM/AM to select the band (FM or AM).
The last received station of the last selected band is tuned
in.
• Each time you press the button, the band alternates
between FM and AM.
Ex.: When the FM band is selected.
2
Press FM/AM TUNING 5/∞ on the
front panel repeatedly until you
find the frequency you want.
FM/AM
RX–5032V AUDIO/VIDEO CONTROL RECEIVER
FM/AM MEMORY
PRESET 5/∞
Remote
NOT
STANDBY
and
STANDBY/ON
STANDBY
and
STANDBY/ON
Remote
NOT
Remote control
FM/AM
Notes:
• When you hold FM/AM TUNING 5 / ∞ in step 2 , the frequency keeps
changing until a station is tuned in.
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
• When an FM stereo program is received, the STEREO indicator also
lights up.

Using Preset Tuning

Once a station is assigned to a channel number, the station
.
can be quickly tuned in. You can preset up to 30 FM and
15 AM stations.

Storing the Preset Stations

Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start again from step 2 .
1
Tune in to the station you want to preset
.
(see "Tuning in to Stations Manually").
If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting
the FM Reception Mode" on page 21.
2
Press MEMORY.
The CH– indicator lights up and the channel number
position will flash on the display for about 5 seconds.
Ex.: When the FM band is selected in step 1 .
3
Press FM/AM PRESET 5/∞ to select a
channel number while the channel number
position is flashing.
Ex.: When channel number "3" is selected.
TO BE CONTINUED TO THE NEXT PAGE
DISPLAY MODE
Remote
NOT
20