Immersing The Cleaner; Electrical Connection; Programming The Cleaning Cycles - Zodiac Vortex 3 Instructions For Installation And Use Manual

2.2. IMMERSING THE CLEANER

Do not allow bathing when the cleaner is in the pool.
Immerse the cleaner in the water (Diagram 7 1) vertically and move it slightly in all directions (7 2) so that the
air in the robot is expelled.
It is imperative that the cleaner sinks to the bottom and comes to rest without intervention from you. Spread
the cable out over the pool. For optimum operation we recommend that you place the caddy with the control
box midway down the length of the pool.

2.3. ELECTRICAL CONNECTION

Diagram 9
If you use an extension cable to connect your cleaner to the power supply, ensure the control box is
placed no less than 3.5 meters from the pool edge.

2.4. PROGRAMMING THE CLEANING CYCLES

2.4.1. Description of keys and indicator diodes
Program I: Maximised cleaning of the pool floor in minimum time. Duration 1.30 hr.
Program II: Intense cleaning of the pool floor and pool sides, including the waterline. Duration 2.30 hr.
OFF button: used to cut the cleaner power supply at the end of a cleaning cycle.
APPLIES FOR VORTEX™4 ONLY:
Decreases cleaning time by 30 min
H03606 00.A2.EN
x Place the control box at a distance of at least 3.5 meters from the pool
edge and away from direct sunlight; it can either be placed on the ground
or attached to the caddy.
x Connect the cleaner cable to the control box (Diagram 9 1 & 9 2) and
lock the connector by firmly tightening the ring by turning it clockwise.
Make sure the connector is sufficiently pushed into place, if this is not the
case repeat operation (9 2).
x Connect the power cable. Only connect the control box to a power
outlet protected by a 30 mA maximum ground fault circuit breaker (if in
doubt contact a qualified electrician). Ensure that the plug is
permanently and easily accessible.
. Increases cleaning time by 1 hr
Ver. 05/2011
Diagram 7
Diagram 8
EN
4