Using The On-Screen Menus; Selecting The Source To Play; Using The Dsp Modes; Adjusting The Front Speaker Output Balance - JVC LVT0142-006A Instructions Manual

Using the On-Screen Menus

You can use the Menus on the TV screen to control the receiver.
To use this function, you need to connect the TV to the MONITOR OUT jack on the rear panel (see page 6), and set the
TV's input mode to the proper position to which the receiver is connected.
• When the TV's input mode is incorrect; for example, a different video input or TV tuner mode is selected, you
cannot show the Menus on the TV screen.
On-Screen Operation buttons (on the remote control)
/I
SOUND
CONTROL
TV VCR AUDIO
ON SCREEN
SET EXIT CD-DISC
DELAY TEST SURROUND
1 2 3
EFFECT – CENTER +
4 5 6
MENU – REAR•L +
7/P 8 9
100+ – REAR•R +
RETURN
+10 0 10
ENTER
VOLUME VCR CH TV VOL. TV CH
SLEEP ONE TOUCH TV/VIDEO
OPERATION
CD
VCR
RM-SR668XU
REMOTE CONTROL
Selecting the Source to Play (Also see page 8)
1. Press ON SCREEN SET.
2, 8, 4, and 6 buttons on the 10 keys work as % / fi / @ / # for
ON SCREEN operations.
2. Press any one of % / fi / @ / #.
The MAIN MENU appears on the TV.
Shows the buttons you can use on the current
menu.
In this case, use % / fi to move
and @ / # to select, adjust or set the item.
Notes:
• If your TV is not of the PAL color system, the TV screen will be
distorted.
• The on-screen display will disappear if no operation is done for
about 1 minute.
3. Press % / fi to move
4. Press @ / # to select the source.
5. When you finish, press ON SCREEN EXIT.
The menu disappears from the TV.
21
ON SCREEN
SET EXIT
TEST
2
EFFECT – CENTER +
4 6
– REAR•L +
8
up and down,
to "SOURCE."
Activating the DSP Modes (Also see page 19)
1. Press ON SCREEN SET.
2, 8, 4, and 6 buttons on the 10 keys work as % / fi / @ / # for
ON SCREEN operations.
2. Press any one of % / fi / @ / #.
The MAIN MENU appears on the TV.
3. Press % / fi to move
to "MODE."
4. Press @ / # to select the
DSP mode you want to
use.
5. When you finish, press ON SCREEN EXIT.
The menu disappears from the TV.

Adjusting the Front Speaker Output Balance

(Also see page 10)
1. Press ON SCREEN SET.
2, 8, 4, and 6 buttons on the 10 keys work as % / fi / @ / # for
ON SCREEN operations.
2. Press any one of % / fi / @ / #.
The MAIN MENU appears on the TV.
3. Press % / fi to move
CONTROL," then press @ / #.
The SOUND CONTROL menu appears.
4. Press % / fi to move
to "BAL." (Balance).
5. Press @ / # to adjust
the balance.
6. When you finish, press ON SCREEN EXIT
repeatedly until the menu disappears from the
TV.
to "SOUND
SOUND CONTROL
SURROUND LEVEL
TONE CONTROL
BAL.:R-21
BASS BOOST :OFF
INPUT ATT :NORMAL
NEXT PAGE
:OPERATE