Table of Contents
Advertisement
9. At ALL other hangers: Orient the hanger perpendicular to reflector - DO NOT fasten to reflec-
tor
10. At the burner end, install the reflector end cap inside of the extended inner reflector
Align holes top and sides with the slotted holes in the reflector
Fasten together using the three bolts/nuts provided
NOTE: The end cap position is between the tube flange and the first hanger. The end
cap extends below the hanger (see FIG 7)
11) Suspend the next two hangers so that they are positioned within 6 to 24 inches (15 to 60
cm) of each end of the tube
NOTE: Tubes are 120 inches (305 cm) in length, with a swage overlap of 4 inches (10
cm) = NET length of tube in system is 116 inches (295 cm)
12) Slide a Torctite coupler over the swaged end of the first tube, past the swage.
NOTE: 200,000 Btuh: A special stainless steel coupler is provided for the connection
of the first to second tubes.
13) Install the next tube on to the hangers
160,000 & 200,000 Btuh MODELS: GO TO SECTION 9.1
COUPLING OF 1ST & 2ND TUBES
ENSURE THAT THE WELDED SEAMS OF THE 1st & 2nd TUBES FACE DOWN
14) Slide the second tube over the swage of the first tube and snug against the swage shoulder.
Ensure that the swage on the first tube is fully inserted into the second tube
FIGURE 9 TUBE CONNECTION
15) Center the tube coupler over the tube joint and
16) Slide a Torctite coupler on to the exposed swaged end of the second tube
17) Check that the installed tube is level and in alignment with the tube before it - make adjust-
ments at hangers as required
18) Install a reflector over the second tube - the inner reflector extension must face toward the
burner
Insert reflector through the 'downstream' hanger first, then slide back though the
hanger closer to the burner
TORQUE THE COUPLER BOLTS TO
17
NOW
FOR SPECIAL
40
FT
UHE / EIH I&O Manual
RD: MAY 2013
/
.
LBS
IM100205
RL: 03D
Advertisement
Table of Contents
