Sanyo SPW-C483GYH8 Service Manual page 176

1. Troubleshooting
1. Troubleshooting
This picture shows the service check display.
UNIT No.
UNIT No.
1–1
R.C.
No.
Refrigerant
Circuit No.
Alarm message
c.
A maximum of 4 alarm messages can be accessed by pressing either SET TEMP button
MODE
SET TEMP.
FAN SPEED
For example, if the last four alarm messages were, in order of occurrence from oldest to most recent, P01, P02, P04,
and most recently E01, then the display will be shown as below when you press
press button you can repeat the display, then the first message will be shown again.
1
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
If there are no alarm messages, the display shows:
No.
CODE No.
CODE No.
CHECK
SERVICE
0358_M_I
Past
Present
Present
Past
0359_M_I
2
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
Alarm message
III - 27
NOTE Pressing CL (Clear) button will clear all
the service history.
... accessed in order of "Past
... accessed in order of "Present
button four times. The 5th time you
3
UNIT No. UNIT No.
R.C. No. R.C.
CODE No.
CHECK
SERVICE
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
Service Procedures
or as follows.
Present".
Past".
4
No.
CODE No.
CHECK
SERVICE
0360_M_I
SM830052
3