Table of Contents
Advertisement
I N S T A L L A T I O N
6. Route the cable from below the dash
up to the lower left corner of the driver
side windshield. (Figure 4)
7. If needed, remove side panels to help
see while routing.
8. Leave enough length between the dash
and the end of the CS/CTS connector for
easy CS/CTS install.
NOTE: For a clean look, the cable can
be hidden behind the dash plastic and
the door frame weather strip.
9. Using the supplied zip ties, fasten the
EAS connectors underneath the overhang
which runs across the top of the fi re wall.
(Figure 5)
10. Keep the JAB assembly close to the
driver side.
Figure 5 - Securing JAB (Looking from the front of the truck to back)
40
D o d g e
I n s t a l l a t i o n
CS/CTS
Connector
Figure 4 - In Cab Routing
Zip Ties
To CS/CTS
JAB Assembly
J u i c e
I n s t r u c t i o n s
Grommet
Fire Wall
Overhang
Advertisement
Table of Contents
