Connecting To Fuel Pressure Sensor; Boost Elbow Installation (Optional) - Edge Products Juice Installation Instructions Manual

I N S T A L L A T I O N
1. Locate Fuel Pressure Sensor connector. (Figure 6)
2. Remove vehicle Fuel Pressure Sensor connector and connect the Edge Har-
ness Fuel pressure sensor connector "T" in between the vehicle harness and the
sensor itself. (Similar to Figure 7 on previous page)
1. Using the 5/16" socket, loosen the two clamps securing the air induction hose
to the air fi lter housing and the turbo inlet. (Figure 8)
2. Remove the hose and set it aside.
3. Using the pliers, remove the crimp style clamp from the hose on the brass
fi tting located on the now exposed lower front side of the turbocharger.
4. Remove the hose from the brass fi tting and dispose of the crimp style clamp.
5. Using the 7/16" wrench, unscrew the stock brass fi tting out of the turbocharg-
er housing.
6. Using the 7/16" wrench, install the supplied brass fi tting. Tighten while being
careful not to over-tighten. (Figure 9)
7. Slip the supplied hose clamp onto the stock hose, install the stock hose
onto the supplied brass fi tting and tighten the hose clamp with the ¼" socket.
8. Reinstall the stock air hose onto the air fi lter housing and turbocharger inlet.
9. Using the 5/16" socket, tighten both clamps securely.
NOTE: YOUR JUICE MODULE INSTALLATION IS NOT COMPLETE. RE-
FER TO THE "EGT PROBE INSTALLATION" SECTION TO CONTINUE.
Figure 8 - Turbo View
OEM brass fi tting
22

CONNECTING TO FUEL PRESSURE SENSOR

BOOST ELBOW INSTALLATION (OPTIONAL)

D o d g e
I n s t a l l a t i o n
Figure 9 - Installed Boost Elbow
Edge Supplied Elbow
Hose Clamp
J u i c e
I n s t r u c t i o n s
Hose