Connecting To Transmission (Standard) - Edge Products Juice Installation Instructions Manual

D o d g e
I n s t a l l a t i o n

CONNECTING TO TRANSMISSION (STANDARD)

NOTE: When the Power Take-Off (PTO) plate is removed ALL of the gear
lube from the transmission will drain out – Ensure that you have the COR-
RECT replacement oil prior to removing the PTO plate. See the Dodge service
manual for replacement gear lube type.
1. Using a 14 mm wrench, remove the lowest bolt on the PTO cover plate and
drain the transmission fl uid.
2. Unbolt the remaining fi ve bolts to the PTO cover plate and remove it com-
pletely.
3. Using a 5/ 16" or 21/64" drill bit, drill a hole in the PTO cover plate in the
location shown in fi gure 18.
4. Using a 1/8" NPT tap, thread the hole in the PTO cover plate.
5. Apply Tefl on tape or pipe thread sealant to the transmission temperature sen-
sor and thread it into the PTO cover plate.
6. Clean the surface of the PTO cover plate and transmission . Apply an au-
tomotive gasket silicone to the plate surface that will come in contact with the
transmission.
7. Re-attach the plate cover to the transmission and connect the sensor cable to
the sensor.
8. Refi ll the transmission with fl uid.
NOTE: YOUR JUICE MODULE INSTALLATION IS NOT COMPLETE. RE-
FER TO THE "EGT PROBE INSTALLATION" SECTION TO CONTINUE.
Truck Front
(Driver Side)
J u i c e
I n s t r u c t i o n s
Bell Housing
Figure 18 - Manual Transmission (Driver Side)
I N S T A L L A T I O N
PTO Cover Plate
Transmission
17