Connecting To Map Sensor; Connecting To Data Link - Edge Products Juice Installation Instructions Manual

D o d g e
I n s t a l l a t i o n
1. Disconnect the stock wiring harness from the boost sensor located at the rear
of the fuel fi lter housing (Near the top of and on the engine block). See Figure 5
2. Plug the Edge harness MAP connectors in between the truck MAP sensor and
the truck MAP sensor cable. (Figure 6)
NOTE: The MAP sensor 'T' shown in Figure 6 is for the 1998.5 - 2000 Juice.
The 2001 and 2002 harnesses have different sensor connectors, but in the
same location. Refer to Figure 5 for truck connector locations.
Figure 5 Connector Figure 5 - Connector
Locations
1. Locate the Data link connectors:
• 1998.5 - 1999: The triangle shaped connector is located on the driver's side
of the engine in the wiring harness near the power steering pump.
• 2000 - 2002: The three pronged fl at connector is located on top of the fuel
lift pump that is located on the driver's side of the engine directly below the
MAP sensor. (The 2000 must use the 2000 Data link Adapter.)
NOTE: On some 2001 trucks the Data Link connector can be located on the
driver's side of the engine in the wiring harness near the power steering pump.
2. Replace the protective plug on the truck Data Link with the Juice harness
Data Link Connector. (Refer to Figure 5 above)
J u i c e
I n s t r u c t i o n s

CONNECTING TO MAP SENSOR

98.5-02 MAP Sensor
00-02 Data Link
98.5-99 Data Link

CONNECTING TO DATA LINK

I N S T A L L A T I O N
Truck Harness
Sensor (Engine Side)
Edge MAP Connectors g
Figure 6 - "T" Assembly
11