Table of Contents
Advertisement
D o d g e
I n s t a l l a t i o n
Figure 2 - Probe Insertion
Figure 3 - 90 Degree
To Fire wall
Tightened Position
Starting Position
CAUTION: Do not bend the probe after installed. If needed, loosen the
probe nut, adjust the probe, and re-tighten. Bending the probe tubing will
result in a faulty probe. (Figure 4)
Correct
J u i c e
I n s t r u c t i o n s
Nut
Fitting
Flush
Probe
90 Deg.
Figure 4 - DO NOT BEND
I N S T A L L A T I O N
6. Install the probe into the fi tting,
and tighten the top nut of the fi tting
just tight enough to keep the probe
fi rmly mounted. (Figure 2)
7. Make sure that the probe cable
is positioned to allow best path and
minimal bending for routing to the
fi re wall.
NOTE: The probe will move ap-
proximately 90 Deg. clockwise in
the direction the nut is tightened.
Before fully tightening the nut,
make sure the cable starts 90
Degrees from the fi nal resting po-
sition. When tightened, the cable
will be correctly positioned.
Wrong
37
Advertisement
Table of Contents
