Step 3: Register The Wfr And Its Applications; Access The Wfr Via Its Lan 1 Ip Address - M86 Security 350 Installation Manual

M86 web filter and reporter
Hide thumbs Also See for 350:
Table of Contents

Advertisement

Step 3: Register the WFR and its Applications

Next you will register the WFR and its applications online. For this step you will
need your network administrator to provide you the IP range and netmask of
machines on the network the Threat Analysis Reporter application will use for
monitoring bandwidth on your network

Access the WFR via its LAN 1 IP Address

A. Launch an Internet supported browser:
• Firefox 3.5
• Internet Explorer 7 or 8
• Safari 4.0
B. In the address field, type in the LAN 1 IP address you assigned to the WFR in
Step 1A (Quick Start setup) or Step 1B (IP / LAN1 and 2). Be sure to use "https"
and port :8443 for a secure connection. For example, if the WFR were
assigned an IP address of 10.10.10.10, you would enter https://
10.10.10.10:8443 in the browser's address field.
C. Click Go to display the security issue page:
• If using Firefox, proceed to Accept the Security Certificate in Firefox.
• If using IE, proceed to Temporarily Accept the Security Certificate in IE.
• If using Safari, proceed to Accept the Security Certificate in Safari.
• If the security issue page does not display in your browser, verify the
following:
• The WFR is powered on.
• The WFR is connected to the same hub as your router/firewall.
• Can the administrator workstation normally connect to the Internet?
• Is the WFR plugged into a switch instead of a hub?
• Do you have both LAN ports connected to your network hub?
• Is there a caching server?
• Is the administrator workstation able to ping the WFR's LAN 1 IP
• If pinging the IP address of the WFR is unsuccessful, try restarting the
• If still unsuccessful, contact an M86 Security solutions engineer or
M86 S
I
G
ECURITY
NSTALLATION
UIDE
address? (To ping the WFR using the Command Prompt in Windows XP,
Vista, and 7, go to Start > All Programs > Accessories > Command
Prompt, type in Ping and the IP address using the x.x.x.x format—in
which each 'x' represents an octet—and then press Enter.)
network service or rebooting the WFR.
technical support representative.
I
S
S
3: R
NSTALL THE
ERVER
TEP
WFR
A
EGISTER THE
AND ITS
PPLICATIONS
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

550

Table of Contents