Power On The Wfr; Power Up A 300 Series Model; Power Up A 500 Series Model - M86 Security 350 Installation Manual

Power on the WFR

Power up a 300 Series Model

A. Make sure the power adapter is plugged into the back of the chassis and
connected to the power cord.
B. Plug the power cord into a power source with an appropriate rating.
WARNING: It is strongly suggested you use an uninterruptible power supply.
C. Go to the LCD panel on the front of the chassis, and press down the green
checkmark key for three seconds:
D. When the LCD panel displays a message that indicates the WFR is running,
proceed to the following set of instructions:
• For Monitor and Keyboard Setup, go to Login screen.
• For Serial Console Setup, go to HyperTerminal Setup Procedures.

Power up a 500 Series Model

A. Make sure the power cord is plugged into the back of the chassis.
B. Plug the power cord into a power source with an appropriate rating.
WARNING: It is strongly suggested you use an uninterruptible power supply.
C. Remove the bezel and press the large button at the right of the front panel:
D. Replace the bezel on the front of the chassis. When the LCD panel displays a
message that indicates the WFR is running, proceed to the following set of
instructions:
• For Monitor and Keyboard Setup, go to Login screen.
• For Serial Console Setup, go to HyperTerminal Setup Procedures.
M86 S I G
ECURITY NSTALLATION UIDE
I S S 1A: Q
NSTALL THE ERVER TEP
S S P
UICK TART ETUP ROCEDURES
17