Table of Contents
Advertisement
Step 1B: LCD Panel Setup Procedures
LCD Panel
A. Connect the AC power cord(s) to the back of the chassis and plug the cord(s)
into a UPS power supply unit.
B. Power on the server following the instructions at Step 1A: Quick Start Setup
Procedures, Power on the WFR.
LCD panel keypad
To configure the WFR via the LCD panel on front of the chassis bezel, use the
keypad located to the right of the LCD screen.
The keypad consists of the following keys:
• On a 300 series model: Up arrow, down arrow, left arrow, right arrow, check-
mark, and "X" keys.
• On a 500 series model: Up, down, left, right, CANCEL, and ENTER keys.
300 series keypad at left, 500 series keypad at right
To display software status information about the WFR, press the right (arrow) key.
To go to the LCD Menu, press "X" / CANCEL. Pressing "X" / CANCEL again returns
you to the software status display.
LCD Menu
The LCD Menu tree includes the following two main menu selections:
• LCD Options - This choice includes options for viewing the LCD display and
monitoring the WFR once it is configured and running on the network. Informa-
tion about using LCD Options is included in this document after the M86 menu
sub-section.
• M86 menu - Many of the menu items in this sub-section are used for configuring
the WFR unit.
The menu tree displays an arrow to the left of the currently selected menu item.
Use the up or down (arrow) keys to navigate the menu. After making your menu
selection, press the checkmark / ENTER key to accept your selection.
M86 S
I
G
ECURITY
NSTALLATION
UIDE
I
S
S
1B: LCD P
NSTALL THE
ERVER
TEP
S
P
ANEL
ETUP
ROCEDURES
27
Advertisement
Table of Contents
