Restarting - Mercedes-Benz 2013 SL Operator's Manual

Tire pressure
554
If the vehicle has been parked for longer than
20 minutes, the
displayed after driving a few
minutes message appears.
After a teach-in process, the tire pressure
monitor automatically detects new wheels or
new sensors. As long as a clear allocation of
the tire pressure value to the individual
wheels is not possible, the
Monitor Active
of the tire pressure display. The tire pressures
are already being monitored.
Tire pressure monitor warning
messages
If the tire pressure monitor detects a
significant pressure loss on one or more tires,
a warning message is shown in the
multifunction display. A warning tone also
sounds and the tire pressure warning lamp
lights up in the instrument cluster.
Each tire that is affected by a significant loss
of pressure is highlighted in the pressure
display.
If the Correct Tire Pressure
X
appears in the multifunction display, check
the tire pressure on all four wheels and
correct it if necessary.
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be
displayed for the wrong positions for a
short time. This is rectified after a few
minutes of driving, and the tire pressures
are displayed for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor,
all existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the
reference values for monitoring. In most
cases, the tire pressure monitor will
automatically detect the new reference
values after you have changed the tire
Tire pressure will be
Tire Pressure
message is shown instead
message
pressure. However, you can also define
reference values manually as described here.
Set the tire pressure to the value
X
recommended for the corresponding
driving situation on the Tire and Loading
Information placard on the B-pillar on the
driver's side ( page 547).
Y
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 547).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock.
Press t or u on the steering wheel
X
to select the Serv.
Press the s or r button to select
X
Tire Pressure.
Press the a button.
X
The multifunction display shows the
current tire pressure for the individual tires
or the Tire pressure will be
displayed after driving a few
minutes message.
Press the r button.
X
The Use Current Pressures as New
Reference Values
the multifunction display.
If you wish to confirm the restart:
Press the a button.
X
The Tire Press. Monitor Restarted
message appears in the multifunction
display.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
If you wish to cancel the restart:
Press the % button.
X
The tire pressure values stored at the last
restart will continue to be monitored.
menu.
message appears in