Table of Contents
Advertisement
Getting Started
During Initial Startup
(Continued)
Automatic Registration of Cameras
(continued)
6
Use the [SKIP] button to select [OK], followed by
pressing the [16/ENTER](ZOOM IN/ENTER)
button
● The [Configure Device] screen appears.
7
Enter the password for the network camera
● Press the [KEY] button to display the software keyboard.
(A Page 28)
● Use the keypad to move the mouse cursor over the
software keyboard.
● Pressing the [16/ENTER](ZOOM IN/ENTER) button
inputs the characters on the keyboard into the password
field.
Memo :
● For cameras with the Analog-In message (analog cameras),
7
proceed to Step
. Password is not required. (VR-N900U)
8
After password entry is complete, press [KEY]
again the close the software keyboard
9
Use the [SKIP] button to select [OK], followed by
pressing the [16/ENTER](ZOOM IN/ENTER)
button
10
Repeat the steps from 5 to 7 for every detected
camera
● The [Camera Record Setting] screen appears.
11
Specify the display rate for each camera such
that the total display rate of all cameras does not
exceed 80 ips (VR-N1600U/E)/60 ips (VR-N900U).
● The default display rate is set at 8 ips. The maximum
display performance of 80 ips will be exceeded if 11 or
more cameras are detected. In this case, you will need to
adjust the display rate of each camera using the following
steps. (VR-N1600U/E)
● The default display rate is set at 8 ips. The maximum
display performance of 60 ips will be exceeded if 8 or
more cameras are detected. In this case, you will need to
adjust the display rate of each camera using the following
steps. (VR-N900U)
Note :
● The recording rate may drop if the total display rate of all
cameras exceeds 80 ips (VR-N1600U/E)/60 ips (VR-N900U).
A
Press the [SKIP] button to select Device Manager
●The device at the top is selected.
B
Use the [2/D] or [10/0/E](8/E) button to select a device
A
B
Advertisement
Table of Contents
