Table of Contents
Advertisement
Others
Default Value List
(continued)
User Administration (Distribution Settings A Page 118)
VR-N1600U/E
User
vr-n1600
Administrator
VR-N900U
User
vr-n900
Administrator
HDD Utility (Advanced Settings A Page 116)
NAS User Settings
Password
User name
Auto Archive
Enable archiving to internal HDD
Troubleshooting
Symptom
Power cannot be turned on.
Camera is not automatically detected.
Unable to control using [REC] and [PLAY].
Images are not recorded in the recording control
mode.
Unable to play back audio sound.
Operation of the unit is disabled.
The message below appears after turning on the
power.
COMS Settings Wrong CMOS Date/ Time Not Press
F1 to Run SETUP Press F2 to load default values
and continue
Password
Type
[vr-n1600]
Basic user
[None]
[Windows or Active Directory user]
Password
Type
[vr-n900]
Basic user
[None]
[Windows or Active Directory user]
Check to ensure that the power cable has been plugged in correctly.
Check to ensure that the power switch on the rear panel is switched on.
Follow instructions in the camera's [Instruction Manual] to check the IP address
settings.
When the IP Lease feature is in use, turn OFF the camera and ON again with this unit
started up.
Check to ensure that the operation lock is not turned on.
Check the [Camera Recording Settings].
Check to ensure that the scheduler is set to online.
Check to ensure that the camera is in the recording control mode.
Check to ensure that the audio item of the camera device is set to Enabled in the
[Camera Record Setting] menu.
Check to ensure that audio is selected in [Audio].
Press and hold the [FUNCTION] button on the front panel, and press the [OPERATE]
button for 7 seconds or longer to shut down the power forcibly.
Memo :
● When the power is forcibly shut down, recorded images that are not archived
(A Page 108) may not be properly played back.
The built-in backup battery level is running low.
Consult your nearest JVC service center.
[None]
[None]
[Selected]
Action
Advertisement
Table of Contents
