Changing Monitor
Resolution
You can switch the resolution of the VGA output using the following
procedures.
● Press and hold the [FUNCTION] button, and press the [14/
ZOOM OUT](ZOOM OUT/CANCEL) button at the same time.
BPressing the button each time increases the resolution
value.
● Press and hold the [FUNCTION] button, and press the [15/
ZOOM IN](ZOOM IN/ENTER) button at the same time.
BPressing the button each time decreases the resolution
value.
Preset
: 1024 x 768 (Default value)
Values
1280 x 768
1280 x 1024
1600 x 1200
WARNING
LIVE/BROWSE
ALARM
OPERATE
SELECT
HDD
LOCK
REC CONTROL
PTZ/PRESET
SERIAL
CANCEL
ZOOM OUT
ZOOM IN
ENTER
[14/ZOOM OUT]
[FUNCTION] Button
Button
[15/ZOOM IN] Button
[ZOOM OUT/
[FUNCTION] Button
CANCEL] Button
[ZOOM IN/ENTER] Button
Memo :
● Selecting a resolution not supported by the monitor may prevent
normal monitor synchronization.
VR-N1600U/E
FUNCTION
SEARCH
KEY
ALARM CLEAR
REC/STOP
STOP(PB)
PLAY
VR-N900U
Precautions when
Changing Settings
Note that any incorrect changes made to the settings of this unit
may cause it to malfunction.
● Before making any changes, save the current settings to [Flash
Memory Utility] (A Page 111) to allow you to restore the
previous settings should anything go wrong.
● It is recommended that you save the setting data before making
any changes.
● The section at the bottom left of NVR Viewer might not be
operative depending on the monitor resolution. In such a case,
double-click the bar of the currently opened upper section to
close it to enable the operation of the lower section.
REV
FWD
SKIP