Connect To Pc Console - Quintum Tenor AS Product Manual

Chapter 3: Installation/Basic Troubleshooting

Connect to PC Console

You will need to connect the Tenor AS to your workstation's serial port via RS-232 connection.
(This connection will be used when you assign an IP address to the unit.) For the instructions below,
it is assumed you are connecting to a Windows PC.
1. Insert the male end of the DB-9 cable into the port labeled Console. (See
nents for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation's serial console port (see your PC documen-
tation for more information about this port).
3-6
Figure 2-4 Connect to PC Com Port
DB-9
Chapter 2: Hardware Compo-
P/N 480-0059-00-00