Appendix C. Do & Don't - BestDuplicator BD18xxL Controller User Manual

Appendix
D. Steps to avoid drives problems.
1 To avoid dust and over-heat temperature.
Overtime, drives and fans tend to build up in dust which could cause slower
burning performances. It is suggested that the unit is placed in an area with the
least amount of dust. It's also suggested that every 6 months the unit should be
"Air dusted". This means you will need to open the side of the case and spray
air dust into the drives or fans to clean the dust. **DO NOT AIR DUST THE
POWER SUPPLY**
Life
Short !!
Low
2 It is very important that all of the drives that the duplicator is using are the same
Capability
brand to prevent compatibility and stability issues.(Diagram on "Do & Don't 5")
Q1: How do we know the data is correct after copy?
Run function "Compare" function to ensure the corrrectness of copied data.
Q2: During Boot up my Duplicator only says 5/6 Drives
Detected.
Ocasionally due to the unit's movement in transit by the courier, cables may
become fall loose. For life and warranty purposes, BestDuplicator does not hot
glue cables into those drives for that reason. Simply open the case door and
If no space, it
check to make sure all cables are plugged in. Please follow Step 4 on "Part A of
would fail to
FAQ Steps to replace drives"
release the
temperature.
Appendix C. Do & Don't
Do & Don't 1
Be sure to use duplicator chassis so that there are
available spaces among drives. Please do not only stack
up drives without using standard chassis.
42
Duplicator Tower
Wall
15cm
If the distance is too sho
heat-releasing failed.
Duplicator T