BestDuplicator BD18xxL Controller User Manual page 40

Appendix
4 Replace new DVD drives into the box. Attach cables/screws back to the new
drive, finally close the doors and replace its original screws to lock the doors.
Make sure you connect all components and cables firmly.
5 Turn on the power again. Check if the LED of the replaced drive is on or not. If
the LED turns on after powering on, continue to test its copy status.
B. Steps to replace controller cards.
1 Turn off the power. From the side, remove the case cover and take out all the
SATA cables attached to each device within the Duplicator. Same removal
methods are used as "A. Steps to replace drives".
2 Take out the controller card from the top case. Insert new controller card.
C. Steps to check power problems.
1 Turn off the power. Switch the power to a different outlet. Sometimes some
power outlets either fail without user notice or do not provide enough power
Recycle
Cause
Components
for the duplicator to be running at maximum performance. If this issue is not
resolved, take any PC Power cord that works on your computer, Gaming
Console, or powering device. Plug it into the duplicator power supply, and try
multiple outlets.
Low Quality
Cause
Capacitor
40
Recycle
Components
Low Quality
Capacitor
Cooler
Drive 1
Space
would
Drive 2
allow air
circulation.
Life
Short !!
Low
Capability
Heat
Cause
Cause
Cooler
Drive 1
Drive 2
Heat
Life
Short !!
Low
Capability
If no space, i
would fail to
release the
temperature