Mitsubishi Eclipse Workshop Manual page 661

LIGHTING SYSTEM -
rront Tum Sisnal
lamp and Front Position
lamplRear
Combination
lamp
54-25
SERVICE POINTS OF REMOVAL
1.
REMOVAL OF FRONT GARNISH
Refer
to
GROUP
51
-
Grille.
2.
REMOVAL OF FRONT POSITION LAMP
(1)
Raise
the
headlamp by using the pop-up switch.
Disconnect the negative
(-)
battery terminal.
(2)
Remove
the front position
lamp.
SERVICE POINTS OF INSTALIATION
3.
INSTALI.ATION OF FRONT TURN SIGNAL
IAMP
lnsert
the
bosses of the
front turn-signal lamp into the clip
areas of the
front
fender. Then. mount the front turn-signal
lamp wrth the mounting
screws.
INSTALI.A,TION OF FRONT POSITION I.AMP
Insert
the
bosses
of
the front position lamp into the clip
area of the turn-signal lamp and the mounting hole on the
body side. Then, mount the front position lamp with the
mounting
screws.
REAR COMBINATION
IAMP
o REMOVAL
AND
|NSTAL|ÄT|ON
Removal stcpe
1. Rear
panel garnish
2. Lid C (Lid D when the right
rear
combination lamp
is
removed or
installed.)
l}+
3.
Rear combination lamp
4.
Gasket
'.',1
@
Mitsubishi
Motors
Corporation
Apr.
1991