Mitsubishi Eclipse Workshop Manual page 389

REAR SUSPENSION
<4WD> -
Rear Suspension Assembly
34-21
I
o
16.
REMOVAL OF REAR SUSPENSION ASSEMBLY
Supporting the
rear suspension assembly with
a trans-
mission jack, move it toward the rear (in the direction of
the fuel
tank).
Gradually lower
the transmission
jack, avoiding contact
with the
stabilizer bar and the
propeller
shaft.
Caution
1.
Ensure
that the propeller shaft does
not
bend
greatly.
2.
Ensure
that the
löbro
joint
does not receive any
shock.
NOTE
The lowering of the
rear suspension assembly from the
transmission jack requires three individuals due
to
the
amount
of weight being handled (one on the differen-
tial, and one on either side of the
lower
arm).
(3)
In order
to protect the
rear suspension assembly dust
shield, support
the lower
arm
balljoint with
a wooden
block.
INSPEGTION
.
Check crossmember
for
cracks
or other
damage.
SERVICE POINTS OF
INSTALLATION
8.
INSTALIANON
OF PROPELLER SHAFT INSTAUÄNON
BOLT
AND
NUT
Install the propeller shaft to the differentialcarrier, ensuring
that
the
mating marks are
aligned.
3.
INSTALLATION OF PARKING BRAKE CABLE
END
NOTE
Connecting a parking brake cable end to parking brake lever
and
prying
up
the parking brake lever, the installation of the
other cable end
will
be
easy.
(1)
(2')
t
o
I
O
o
Ü.
Ortlt'Uu|hl
PvuuB9010