Brother HL-5130 Service Manual page 259

1. Controller Firmware
Writing procedure (For AVA file)
1) Choose Start...>Program...>Accessory...>Command prompt
Since the DOS window is opened, move the ZL2E folder.
Type c:+ ENTER, CD \ZL2E + ENTER.
2) Turn off the printer. Connect the USB cable to the printer. Open the front cover, and turn
on the printer while holding down the Go button. When the printer enters into the
inspection mode, the Toner LED is ON. Release the Go button. Holding down the Go
button will cause the LEDs to turn ON in the order Toner → Drum → Paper → Status →
Toner + Drum → Drum + Paper → Paper + Status. Release the Go button when the
Toner and Drum LEDs light up.
3) Type "Batch file" name and "AVA file" name, then press ENTER key.
Example) FW5170DN LZ0011_A.AVA + ENTER
Data is sent to the printer via the USB cable, and start writing.
(While the data is sent to the printer; Status LED (orange) blinking.)
(While writing the firmware; Status LED (red) blinking)
Even if the batch file is completed, the data is still transmitted or the writing procedure
continues. So, be sure NOT to shut down the Windows system, turn the printer off, unplug
the cable and turn the PC off until all the LEDs light up. Re-writing may be impossible if
writing procedure goes wrong.
4) After finishing writing, all the LEDs light up.
NOTE;
Plug and Play will run automatically when the printer is rebooted, then the printer driver (copy
2) will be created. (START>Setting>Printer) Delete the created printer driver (copy 2).
HL-5130/5140/5150D/5170DN SERVICE MANUAL
7-17