Printing On Transparencies - Brother HL-5130 Service Manual

NOTE: When you put envelopes in the MP tray, please remember the following;
*During printing, the inside tray rises to feed envelopes into the printer.
*The side to be printed on must be face up.
*Put the leading edge (top of the paper) in first and push it gently into the tray.
(7) Send the print data to the printer.
(8) After you finish the print job, close the back output tray..
NOTE: *If envelopes get smudged during printing, in the printer driver select MP Tray as the
Paper Source for a straight paper path. Then, set the Media Type to Thick Paper or
Thicker Paper to increase the fixing temperature.
*Envelopes joints that are sealed by the manufacturer should be secure.
*All sides should be properly folded without wrinkles or creases.
4.5

Printing on transparencies

You can print on transparencies from the paper tray, manual feed tray or MP tray.
Printing on transparencies from the paper tray
(1) Select the Paper Size, Media Type, Paper Source, and other settings in the printer
driver.
(2) Pull the paper tray completely out of the printer.
(3) While pressing the blue paper-guide release levers, slide the paper guides to fit the
transparency size. Check that the guides are firmly in the slots.
(4) Put transparencies in the tray. Check that the transparencies are flat and below the
maximum paper mark. Do not put more than 10 transparencies in the tray at any one
time, or it may cause a jam.
(5) Put the paper tray firmly back in the printer.
NOTE: Pull out the support flap to prevent transparencies from sliding off the top output
tray.
(6) Send the print data to the printer.
HL-5130/5140/5150D/5170DN SERVICE MANUAL
Fig.2-26
Fig.2-27
2-21